HCBBS Forum (English)
Submit Chemical Projects / Find Solutions
Amplify Your Requirements on a Broader Chemical Platform *Engineering · Technology · Equipment · Solutions*
Submit Request

Standards for pressure requirements at the safety valve discharge port

2008-03-03View Original

Thread Content

Requirements for the pressure at the safety valve’s discharge outlet: Is there any pressure requirement at the discharge outlet of a safety valve? If the normal pressure in the pipeline is 1.5 MPa and the activation pressure of the safety valve is 1.8 MPa, can the discharge outlet be connected to a tank to which the fluid flows under normal conditions? Are there any regulations or requirements in this regard? Please provide guidance. We came across a design drawing in which the location of the safety valve’s discharge outlet is different; it’s urgent!!!
Reply #22008-03-03
I’ve never seen a pressure relief line connected back to a storage tank. Typical pressure relief lines are either vented directly or vented after exhaust gas treatment.
Reply #32008-03-04
Yes, it was designed by a design institute; I’m checking the relevant standards!
Reply #42008-03-04
It is possible, but it is necessary to analyze each case on its own. When setting up a safety valve, consideration must be given to the safe release of pressure within that pressure system. If the tank at the discharge outlet is not part of that safety valve’s pressure system, then discharge is permissible; however, in the design of the safety valve, requirements must be specified regarding the pressure behind the valve.
Reply #52008-03-05
Are there any standards I can refer to? Those upstairs, please give some advice!
Reply #62008-10-20
The safety valve is designed to release pressure, usually at 1.1 times the set pressure
Reply #72008-10-20
The safety valve discharges to the on-site vent pipe or flare
Reply #82008-10-22
Toxic or valuable substances are generally collected in specialized discharge tanks; those that can be recycled are recycled as much as possible, while those that cannot be recycled are disposed of after treatment
Reply #92008-10-22
In the case of safety valves on pneumatic conveying equipment (mainly referring to compressed air), their discharge outlets can be connected directly to the atmosphere; For safety valves in hydraulic systems or oil delivery systems, their discharge ports are generally connected to a reservoir.

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.