Sulzer packed tower calculation software
Thread Content
Could some expert please advise us on how to use the Sulzer tower calculation software available on our forum? I see that the tower diameter and height need to be specified – is it used for hydraulic calculations? Please offer your guidance
I have this software, but I can’t transfer files using it – it doesn’t support the RAR format. Last edited by WSL01218 on 2008-6-18 16:58.]
It is used for hydraulic calculations, not for process design; it is necessary to first use simulation software to obtain the required data (or existing process data), and then use those data to carry out hydraulic calculations.
But the data output by this software’s calculations is as follows: Calculated Output: Capacity: 0.0 0.0 0.0 0.0 0.0 0.0; F-Factor: 0.00 0.00 0.00 0.00 0.00 0.00; Spec. liquid load: 0.00 0.00 0.00 0.00 0.00 0.00; Pressure drop: 0.00 0.00 0.00 0.00 0.00 0.00; Flow Parameter: 0.00 0.00 0.00 0.00 0.00 0.00; Liquid Holdup: 0.0 0.0 0.0; Bed pressure drop: 0.00 0.00 0.00. These values change when the type of structured packing is altered; they are not affected by the tower diameter or height. So how does this software carry out hydraulic modeling?
It is related to the tower diameter, and also to the tower height. . . Of course, it doesn’t matter; it only depends on the filler height. There are also Sulzer’s own options for distributors and collectors. . . The formulas, as well as the data for fillers and distributors, are all pre-set; it’s a user-friendly software. . . Additionally, the choice of distributor is very important
5# zbh15818 for calculating packed towers; it’s better to use this: http://www.htcsoft.com/pcpc.zip
Better stuff! But there’s just no manual or tutorial or anything like that! @
Why not download it from the official website? Do it yourself too? ? http://www.htcsoft.com/
This post was last edited by wiseboy on 2010-4-12 23:13. If you want everything to be clear and transparent, don’t use Sulzer’s products. What Sulzer calculates can only be used correctly by them. Some of the calculation results are clearly ambiguous. For example, if the diffusion coefficient is not known, how can the plate height be calculated? ? ? ? ? ? Deceive people? ? ? ? But Sulzer knew exactly what was going on in its own mind.
The tower height and diameter are usually determined by the design institute