Thread Content
The Ainiuba flow meter is a new type of differential pressure flow measurement element developed based on the principle of velocity measurement using pitot tubes. It outputs a differential pressure signal, which is used in conjunction with instruments for measuring differential pressure, to accurately determine the flow rate of various liquids, gases, and vapors in circular or rectangular pipes. Thanks to its advantages such as high precision, low pressure loss, and easy installation, it has gradually replaced orifice plates and other sensing elements, and is widely used in industries such as the power industry, chemical industry, petroleum industry, and metal smelting. To ensure accuracy when measuring, the Aoniuba flow meter is used. In addition to proper installation and use ； The maintenance of the equipment is also very important. This article mainly introduces several pieces of knowledge regarding the equipment maintenance of AnuoBa flow meters. 1. The protection process covers all the main construction steps, including the handling and storage of instrumentation equipment, individual calibration, secondary transportation, lifting, installation, purging, pressure testing, and circuit debugging. 2. The Aniuoba flowmeter should be stored in a weatherproof and dust-proof instrument warehouse; in cold regions, anti-freezing measures should be in place. 3. The Aniuoba flow meters should be arranged according to the characteristics of the project, either by category or by zone, and instrument identification signs should be installed. 4. The individual calibration of the instrument should be carried out in accordance with the instrument’s manual; after calibration, the circuits and components should be reset, and the instrument casing sealed. 5. When handling, lifting, and installing the Aniuoba flow meter, it is necessary to proceed in a careful manner, handling it gently and using appropriate methods for lifting and placing it; moreover, measures should be taken to prevent vibration and collisions. 6. Special protection areas shall be established during the installation and commissioning phase in important locations such as the on-site instrument control room. 7. Instrument components, precision instruments, and small components that are fragile or prone to damage should be stored properly, and it is advisable to install them after the factory building is sealed or before the handover takes place. For more information, please visit the company’s official website at http://www.yb1518.com/. Please retain this link when reproducing the content! http://www.yb1518.com/UploadFiles/2012717112042354.jpg