Thread Content
How should we adjust a turbine flowmeter (http://www.yb1518.com/ProductShow_188.html) before using it for measurement? Let the editor give you a brief introduction! 1. When in use, the liquid to be tested should be kept clean, free of impurities such as fibers and particles. 2. When starting to use the flow meter, the sensor should first be slowly filled with liquid before the outlet valve is opened; it is strictly prohibited to expose the sensor to high-speed fluid flow when it is empty of liquid. 3. The maintenance cycle for flow meters is generally half a year. During maintenance and cleaning, be careful not to damage the components inside the measurement chamber, especially the impeller. When assembling, pay close attention to the positional relationship between the guide elements and the impeller. 4. When a turbine flow meter (http://www.yb1518.com/ProductShow_188.html) is not in use, its internal liquid should be cleaned, protective covers should be placed at both ends of the sensor to prevent dust from entering, and it should then be stored in a dry place. 5. The filter used during operation should be cleaned regularly; when not in use, the liquid inside it should be cleaned as well. Similar to the sensor, it should be covered with a dust cover and stored in a dry place. 6. The transmission cable of the flow meter can be installed overhead or buried (an iron pipe should be used when buried). 7. Before installing the turbine flowmeter (http://www.yb1518.com/ProductShow_188.html), first connect it to a display instrument or oscilloscope, supply power to it, and blow on or manually rotate the impeller to make it spin rapidly in order to check whether there is any display; only after a display is observed should the sensor be installed. If it is not displayed, the relevant components should be checked to eliminate the fault. For more information, please visit the company’s official website at http://www.yb1518.com/. Please keep this link when reproducing the content!