Thread Content
Although electromagnetic flowmeters have good reliability and do not get damaged under normal conditions, due to their operating principle, the sensor electrodes are in constant contact with the liquid; over time, the surface of these electrodes is prone to contamination. Therefore, it is recommended to disassemble and clean the electromagnetic flowmeter once a year to ensure the measurement accuracy of the entire flowmeter. All instruments require maintenance, and electromagnetic flowmeters are no exception. Since electromagnetic flowmeters measure weak electric potentials, it is necessary to eliminate all external interference in order to obtain accurate measurements; therefore, proper grounding is a essential condition for ensuring the stable operation of electromagnetic flowmeters. Typically, grounding is achieved through a grounding ring or a reference electrode within the sensor, as well as the grounding connection of the piping system. After long-term use, electromagnetic flowmeters can accumulate dirt, leading to scaling on the electrodes; this not only reduces their measurement accuracy but also damages the instrument. Therefore, if the electrodes are found to be dirty, they must be cleaned promptly to ensure the accuracy of the measurements. Below are the methods for cleaning electrodes summarized by the editor from experience in using electromagnetic flowmeters, for your reference. These generally include the following: 1. Electrochemical method. 2. Mechanical removal method, which involves installing special machinery on the electrode to carry out the removal. Currently, there are two types: mechanical scrapers, which offer stable performance and are easy to operate. Another method involves installing a wire brush for removing dirt inside the tubular electrode; this approach requires pulling the wire brush to clean the electrode, so it is not very convenient to use. 3. The ultrasonic cleaning method involves focusing the energy of ultrasonic waves at the contact surface between the electrode and the medium, thereby breaking down dirt to achieve cleaning. 4. Electrical breakdown method: This involves applying alternating high-voltage electricity periodically between the electrodes and the medium, thereby breaking down the deposits, which are then washed away by the fluid. The above are the methods for cleaning the electrodes of electromagnetic flowmeters; I hope they will be helpful to everyone. For more information, please visit the company’s official website at http://www.yb1518.com/. Please keep this link when reproducing the content! http://www.yb1518.com/UploadFiles/2012717174126829.jpg