Thread Content
This article is reproduced from: http://www.samson-positioner.com/a/News/233.html. Keywords: Samson. http://www.samson-positioner.com/ Samson valves are widely used in everyday life. When installing such valves, it is essential to be aware of the relevant installation guidelines; following these guidelines can help avoid many troubleshooting issues. Next, we will provide a detailed introduction to the precautions for valve installation. The precautions for installing Samson valves are as follows: 1. The stop valve should be installed so that the flow direction of the medium is in line with the arrow indicated on the valve body. To confine it using medium pressure, valves that are not opened and closed frequently but require strict assurance of no leakage when closed can be installed in reverse. 2. A set of correct installation procedure standards is required. 3. When tightening the compression screw, to avoid damaging the sealing surface on the valve top, the valve should be in a slightly open position. 4. To prevent the valve core from tilting to one side due to its heavy weight, large-sized pneumatic control valves and gate valves should be installed vertically; otherwise, leakage will occur. 5. The valve should be installed in the allowable operating position, taking into account the convenience of maintenance and operation. 6. The liquid valve should be configured with the valve stem at a 10° inclination to the horizontal, in order to prevent the liquid from flowing down the stem and, more importantly, to avoid leaks. 7. After the large air separation tower has been cooled in its natural state, to prevent leaks at normal temperature by avoiding leaks at low temperatures, the flanges of the connecting valves need to be pre-tightened while the tower is still cold. 8. The valve is in a closed state during installation. 9. When installing the valve, it is necessary to clean the sealing surfaces and the interior cavity. It is also important to check whether the packing is properly compressed and whether the connection bolts are tightened evenly. 10. Before positioning, low-temperature valves should be tested for opening and closing as much as possible in a cold state, ensuring smooth operation without any sticking. The above outlines 10 points to keep in mind when installing Samson valves. It is essential to be aware of these points in advance during installation, so as to complete the process more quickly and enable the valves to utilize their full advantages. Shanghai Mengyan Automation Equipment Co., Ltd. Address: Room 1119, Jiahong Building, No. 639 Guangfulin Road, Songjiang, Shanghai. Contact person: Xu Gong. Mobile phones: 18616582302 / 18616582330. QQ: 764861476. Email: sales@shmyzdh.com