Thread Content
Maintenance methods for flat-wire motor production lines: 1. In March, the oil screen used for the gearbox on the flat-wire motor production line will be cleaned using diesel or gasoline. New lubricant can then be added through the inspection window in the middle. (Note whether there is too little lubrication every other month.) You can change the lubricant once a year. Excessive lubricant may cause the transmission to overheat, and motor overload may cause the motor protection switch to trip. Too little lubricant causes the transmission to overheat, increases noise levels, and can result in the transmission seizing up and becoming unusable. 2. During long-term operation, the chains in the flat-wire motor production line may cause the existing lubricant to thermally evaporate. This can lead to chain imbalance during operation, resulting in increased noise, crawling, etc. At this point, you can use a butter chain or lubricant to open the end of the seal plate. 3. Flat-wire motor production line: www.cnhonest.com/product_xnyzdh.html. Never allow water to get into the motor, nor should diesel or liquid organic compounds be applied to it; doing so may damage the motor’s insulation and cause malfunctions. The maintenance method for the speed controller is the same as that for the motor. For the rest, refer to the electrical engineer’s manual for the maintenance of flat-wire motor production lines.