Fill pattern issues in CAD
Thread Content
In CAD, a component has already had its fill applied, but it turns out that this component should be divided into two separate parts. After I perform the division, is it possible to avoid deleting the existing fill and instead modify one fill into two different fills?
I think it’s not possible; perhaps the filling of LZ has been adjusted, and filling it again is a bit troublesome. You can move the previous fill to the side first; once the segmentation is complete, use the fill again, keeping the default settings. Then, using feature matching, brush in the content that was added later.
No, it’s not possible; you have to delete it and fill it in again
Deleting the original padding and repadding it is the simplest and fastest method.
There’s no need to delete everything or break it apart; just trim off half of it along the line between the two parts, fill in the other half, and then align them – this saves half the time, haha