Are the water quality requirements for waste heat boilers lower than those for ordinary boilers?
Thread Content
Are the water quality requirements for waste heat boilers lower than those for ordinary boilers?
The water quality for waste heat boilers is the same as that for ordinary boilers; it must meet the requirements of GB1576-2001 \"Water Quality for Industrial Boilers\" or GB/T12145-1999 \"Water and Steam Quality for Thermal Power Generating Units and Steam Power Equipment\".
I haven’t heard that the requirements are low; they should be the same.
I agree with the view on the second floor; the water quality requirements for waste heat boilers are the same as those for ordinary boilers. The following are the water quality requirements for the waste heat boilers in our facility: Analysis: 1. Total solids in the boiler water: Range ≤ 3000 mg/L 2. Boiler water pH: 10–11 3. PO4-3: 15–20 mg/L 4. Total alkalinity:
Thank you to the person above. May I ask why the gas generation jacketed boilers in ammonia synthesis plants can use the methanol distillation residues, while ordinary boilers cannot?
The water quality requirements for the waste heat boilers in our company are the same as those for ordinary boilers. The specific technical parameters are as follows: Sequence Number, Control Parameter, Control Limit: 1. Total Alkalinity ≤12mmol/L; 2. pH Value 10~12; 3. Chloride Content ≤250PPm; 4. Phosphate Content 10PPm~30PPm. This post was last edited by lyhh9024 on 2009-2-3 at 09:19
The water quality required for waste heat boilers is the same as that for ordinary boilers. Otherwise, various problems such as reduced efficiency and damage will occur.
A waste heat boiler is simply another name for an environmentally friendly and energy-efficient boiler; it is similar to ordinary boilers and heat-electric boilers in that some of them are used for general heating while others are used for power generation. Therefore, the requirements regarding water quality depend on the intended use of the boiler’s steam.
No, its water quality requirements should be the same as those of other boilers, as it also generates steam in a boiler drum, and the quality of the steam produced must meet certain standards as well! !
In response to the reply from floor 5, when we designed the system, the gas generation jacket was also intended to be used for holding the residue from the methanol distillation column bottom. However, after the system was put into operation, it was decided not to use it for gas generation, out of concern that it might cause damage to the jacket. As a result, during operation, the liquid from the column bottom was directly introduced into the gas generation circulation water through pipes, before reaching the jacket. Although this is wasteful, it’s still better than damaging the jacket.
It’s definitely the same~~ Waste heat boilers can also be used for power generation and similar purposes, with the same requirements as power plant boilers
In my opinion, there is a difference indeed, as the largest-capacity waste heat boilers used in mainstream applications are designed for 9F gas turbines, with a main steam pressure of 9.8 MPa – which is much lower than that of the ultra-high pressure/subcritical/ultra-critical boilers used in mainstream power plants. Trying to make them meet those higher standards would be a waste; after all, people tend to go for higher standards rather than lower ones
I disagree with the view expressed on floor 12. Both waste heat boilers and power station boilers use high-temperature flue gas to exchange heat with the water inside the tubes, thereby generating steam. The requirements for water quality are the same, also aimed at preventing oxygen corrosion or scaling. Of course, boilers with different pressure ratings have varying requirements regarding water quality, mainly in terms of the allowable levels of trace ions such as silicon and iron. The water quality for waste heat boilers should meet the same requirements as those for power station boilers of the same pressure class.
The requirements for boiler water are the same. The gas generation jacket boiler in an ammonia synthesis plant can utilize the residues from methanol distillation; the water used in the waste heat boilers of such plants is recycled from the condensates generated during the gas production process, and the steam produced from this water is used internally, with no adverse effects.
I disagree with the view from floor 12. Boiler water quality is classified according to pressure. The pressure in the waste heat boiler is not as high as that in the main boiler, but at the same pressure level, the requirements regarding water quality are the same.
The requirements are the same, as it is determined by the salt content in the steam; this is also to protect the remaining boiler and extend its service life, preventing scaling or corrosion
A waste heat boiler is a boiler that uses industrial waste heat as its energy source, and its internal structure is not very different from that of ordinary boilers. Therefore, the requirements for water quality are the same as well; it is necessary to meet the requirements of GB1576-2001 \"Water Quality for Industrial Boilers\" or GB/T12145-1999 \"Quality Requirements for Water and Steam in Thermal Power Generating Units and Steam Power Equipment\". Otherwise, scaling will form inside quickly, reducing the boiler’s efficiency.