How to adjust the movable arm of a rammer
Thread Content
Due to prolonged use, the movable and fixed arms of our plant’s rammer have suffered varying degrees of deformation – they are narrow in the middle and wide at the edges. How can we adjust this? What tools should be used? Experts, please offer some advice.
Just adjust the screw rod that connects the coal bins on both sides. If there are still problems, you can contact me at 13323073555
The problem is that the fixed arm is too thick, so the screw rods on both sides cannot be adjusted.
Adjust until the linkage in the middle of the movable wall is horizontal
Loosen all the screws on the fixing arm (leave the one in the middle, which is narrower, tight), and use a jack to hold it in place. The movable arm is the same. It is also possible to loosen all the arm screw bolts and adjust them again