What are the requirements for the straight pipe section of a float level transmitter?
Thread Content
What is the typical length range for the flanged straight section (neck) of a float level transmitter, and is it related to the measurement range of the level?
What does it matter if I didn’t notice this problem! The measurement range is determined by the length of the linkage and the swinging angle; the swinging angle is usually fixed, right, around 90 degrees?
It is necessary to ensure the swinging range of the float ball.
Follow the principle of ten first and five last unless explicitly specified in the instructions
Float level transmitter? How is it possible to be in the top ten and bottom five at the same time!
It seems there are no such requirements in this regard. Flowmeters require the pipeline to be straight, usually with a straight section of about ten times the diameter before and after the flowmeter; level gauges, on the other hand, have no such requirements
Generally, a distance of 150–200 mm between the flange surface and the equipment surface is sufficient; professional design or manufacturing services for the equipment can be commissioned； As for the measurement range, it is determined by the lever length of the float.