Calculations related to the quick-opening rod flange
Thread Content
There were also posts on the forum about this topic in the past, but they weren’t clear enough; even after reading them, I didn’t know how to carry out the calculations. So I’m hoping that experts here can provide more guidance to help me overcome this difficulty. The forum mentions that the standard calculation method is based on the formulas in HG20582, but there are too many symbols in those formulas, and I don’t know where to find information about them or how they were derived. The explanations aren’t detailed enough, and perhaps due to my limited skills, it’s difficult for me to understand those formulas. As for using stress analysis, I’ve tried it before as well, but there’s no software available for this purpose. I hope that experts in this field can offer some advice! Thank you very much!
I’m not sure if this will be useful to you: http://bbs.hcbbs.com/viewthread.php?tid=383002&page=1&extra=page%3D1
I saw it, thanks to the brother upstairs!
I’ve also downloaded it; I’ll check it when I have time. Thank you in advance.
It gives rodents a headache just to look at it:@:@