Problems encountered in tower design using SW6
Thread Content
When designing the tower in SW6, all the data is entered correctly, but an error of “Floating point division by zero” always occurs during equipment calculation. What’s going on?
This is caused by the instability of SW6; the probability of it occurring is certain~~ So, just recalculate it! Make sure the data you enter is sufficient for it to perform the calculation!
Reboot the computer to perform another calculation.
There’s no need to restart; just check the data and select the materials again
It’s possible that there was an error in entering that data; please check it carefully
There must be an issue with the data entry; please check it carefully.
Check the data carefully! I suggest you re-enter it – especially the material details. Alternatively, calculate it step by step: first calculate the tower body and the skirt, then the upper head, and afterward the lower head, and so on. If there are any issues, warnings will be given! If that doesn’t work, just re-enter the data
It’s caused by software instability; just re-enter the data and perform the calculation