Standards for ear-type supports
Thread Content
In the standards for container lug supports, I can find diagrams of supports with a diameter of DN300 or more, but I wonder how to draw those with a diameter less than DN300; it isn’t mentioned in the books. Those who want to know please help. This post was last edited by The wise are not confused on 2009-2-6 at 15:36.]
Do it according to DN300 standards, or else ask the workers in the workshop.
I agree with the view on the second floor; however, if you think the size is too large, you can design it yourself, using the calculation methods outlined in Chapter 8, Section 1 of the book \"Design of Chemical Equipment\" on page P244.