Issues regarding the form inspection of Category 6 unshielded network cables
Thread Content
I would like to ask netizens about the issue of the routine inspection for Category 6 unshielded network cables: is such an inspection carried out once a year or once every 3 years? Thank you!
Are you asking about Category 5 and Category 6 network cables? The cross-sectional area of UTP in CAT5 should not be used as a criterion for evaluation; what matters most is the quality of the cable. Cables of high quality may be thinner than those of lower quality, but they still have a lower resistance value. Copper-based network cables cannot be assessed based on their cross-sectional area – what’s important is their performance. It is recommended to carefully check the inspection report of the cable product when purchasing it; if testing is necessary, it is advised to use a FLUKE tester for the test. For gigabit networks, it is recommended to use models of FLUCK4000 or higher; of course, CAT5E (Class 5e) or CAT6 (Class 6) cables should also be used. Issues to consider: electrical conductivity, corrosion resistance, toughness, and strength – rather than the number of square units. However, I’m not sure about the inspection cycle **or how industry standards specify it This post was last edited by jsnjhu on 2009-2-7 21:37.]
How often should it be checked? Are there any regulations in this regard? Once the installation is complete and the inspection passes, that’s it
Most current products are subject to visual inspections, usually once a year. However, the manufacturer mentioned that Category 6 unshielded network cables require inspections every three years – is this true?