What material is used for the lining of these two devices?
Thread Content
What material is used for the lining of these two devices? I searched on the forum but found no relevant explanations. There is a standard; I wonder if it’s available on the forum. Please advise those who know more
There is a discussion on the lining issues of the two components in CPP units in the forum: http://bbs.hcbbs.com/thread-326171-1-1.html
Heat-insulating, wear-resistant lining with tortoise shell mesh.
Thank you for the post on floor 2; I’ve read it. However, the original article contains too many errors in the specifications. Could you provide a download link? It’s also fine if you send it to my email address: lb7209@163.com
Bauxite cement, bauxite fine powder + bauxite clinker.
Insulated and wear-resistant lining for the settler + steel fibers; the regenerator also requires a turtle-shell mesh – if there are relevant standards, I’ll send them to you
The technical specifications SH3531-2003 for heat-insulating and wear-resistant linings contain detailed requirements and explanations
The heat- and wear-resistant lining is made by mixing bauxite cement, fine bauxite powder, and bauxite clinker with water, and it is reinforced with a tortoise-shell mesh.
The settler uses a heat-insulating, wear-resistant lining along with insulation nails