How to do simulation with onXDC?
Thread Content
Can Xinhua onxdc be used for simulation? How to do it?
It can be done. It’s the same as 6.0. The local connection must be working properly ； Or install a Microsoft virtual network card. Only one network card can function properly; two of them won’t work. Enter the address of the local connection or 127.0.0.1 for the IP address. Start vdpu first, and then start onxdc. Last edited by chmyh on 2009-2-19 11:33.]
The simulation for ONxdc is VXcu, but it’s unable to establish a network connection; the XNET.INI file is missing (XDPS is present). Other similar files are also not available in C/WINDOWS/SYSTEM32/. It’s possible that ONXDC isn’t configured in this way. This post was last edited by xxy811225 on 2009-2-19 at 22:56
Start by setting the required node number in the VXCU.INI file located in the VXCU directory. Run onxdc again, and set the site IP in the system settings, using the IP address for local connection. Turn off onxdc and turn it back on to make the IP take effect. It doesn’t matter if the network is not connected; in fact, it is already connected. Try loading a configuration file after downloading it; the operators will all work. Try a few more times.
"It doesn’t matter if the network is not connected; in reality, it is already connected. Is this the case whenever simulation is used, or is it because of the absence of NETDRIVE NE2000? Try loading a configuration file and downloading it – then the operator can be used. "In other words, the operation station and VXCU can communicate with each other?
Try loading a configuration file after downloading it; the operators will all work. "So, the operation station and VXCU can communicate with each other? They can communicate now
1. In SYSCONFIG, it is necessary to configure the IP address and project details. 2. The NODE station number in VXCU must match the station number specified in the configuration file you have downloaded. 3. After installing the virtual network card, make sure the IP address is correct; then open VXCU. 4. Open XDCNET – under normal circumstances, the network status bar will be colored blue