Synthetic Ammonia Process Technology Exchange Area [Daily Question 2009-02-18]

Thread Content

Synthetic Ammonia Process Technology Exchange Area [Daily Question 2009-02-18] How do you carry out the replacement of the operator for the copper melt-based purification gas process? Purpose: Communication and mutual improvement. Hope: Work together to help newcomers progress! I hope the moderator will provide support; I am unable to give ratings at the moment as I am not the moderator of this forum, which is unfortunate. Link: Ammonia Synthesis Process Technology Discussion Area [Daily Question 2009-02-17] How is refined gas produced using the copper bath method during the startup process? Has it been smooth? How long did it take? Synthetic Ammonia Process Technology Exchange Area [Daily Question 2009-02-16] What are the problems associated with the design and use of copper pumps and their inlet/outlet pipes in the production of refined gas using the copper melt method? http://bbs.hcbbs.com/thread-390428-1-1.html Synthetic Ammonia Process Technology Exchange Area [Daily Question 2009-02-15] What are the causes of overcurrent in screw chillers and how to address them? http://bbs.hcbbs.com/viewthread.php?tid=390338&highlight= Synthesis Ammonia Process Technology Exchange Area [Daily Question 2009-02-14] For the refining position (copper melt method), what are the reasons for low pressure at the inlet of the copper pump, and what are the solutions? http://bbs.hcbbs.com/thread-389713-1-1.html This post was last edited by jindin312 on 2009-2-18 13:21 ]