pressure drop
Thread Content
How is the pressure drop in steam pipes calculated? Looking forward to everyone’s advice! This post was last edited by WSL01218 on 2009-2-25 09:31.]
Personally, I think insulation should be taken into consideration; regular gas pipeline calculations will suffice； If it is very long, it is necessary to consider calculating it as a compressible fluid and taking heat losses into account; in such cases, segmented calculation can be used.
Moderator: Why was this post pinned? Thank you
I’d like to know that too too; please give me some advice :)
I can only tell you that what you’re looking for is on page 359 of the power pipeline design manual
Reminder: Please modify the topic title by the poster; it contains too few characters (less than four), which does not comply with the forum’s rules (it may be deleted)
Thank you for the reminder from the 6th floor; I’ve already been warned by the cleaner. I’ll be more careful in the future.
It is available in Volume 2 of the Oil Storage and Transportation Design Manual