Thread Content
Common accident-prone situations in the gas generation workshop I. What to do if the microcomputer freezes? 1. Stop automatic mode and switch to manual operation. 2. Find out the cause before driving again. Example: Check the sensor or connector. II. The hydraulic valve cannot move up or down; solutions: 1. Shut down the furnace immediately and tap on the electromagnetic valve from both sides. 2. Check whether the gate plate has fallen off or become stuck. III. What to do if there is water at the bottom of the furnace: If air flow moves upward when adding coal, the temperature at the bottom of the furnace is low, but the hydraulic valve is in its proper position, then promptly remove the ash and slag from inside the furnace and check whether the water seal at the bottom of the furnace is blocked. IV. True/False level identification: 1. Check the temperature at the channel. 2. Open the Coke drain; if gas is discharged, it indicates a water shortage, while if water is discharged, it means the tank is full of liquid. V. Assessing the quality of reactions inside the furnace: 1. Check the furnace temperature. 2. Examine the coal layer. 3. Check the gas composition. 4. Check the slag condition. VI. What are the advantages of mastering the furnace rod machine? 1. It enables stable temperature in the 5 layers of the furnace. 2. Reduce consumption and improve gas production capacity and quality. 3. It can extend the service life of the ash tray and furnace bottom. VII. There are three situations in which O2 levels rise: 1. Wind tunnels form on the furnace surface. 2. N2 addition did not proceed. 3. The downward gas valve was not fully closed during blowing. Gas generation workshop