Remote starting of pump
Thread Content
In the original design, the pump is started on-site and the equipment has been purchased. Now it is changed to remote automatic start. How to achieve this? Can the remote start of the pump be realized by adding a soft start?
Just tell the electrical instrument to connect remote start and on-site start in parallel.
There are no requirements for the pump, this is the job of the instrumentation and electrical department. Our pumps can be started both on site and in the control room.
Of course remote start can be achieved. Remote start has nothing to do with the device;
I suggest that if you have the conditions for on-site start-up, you should start it on-site. If you don’t start it on-site, it is impossible for people to be there. It is easy for problems to occur when the equipment is just started! :)
There are no requirements for the pump and it can be started remotely. Add wires to the control cabinet and connect analog signals to the control room for remote control.
The electrical and instrumentation can be completely taken care of, so you can rest assured.
There are no requirements for the pump and it can be started remotely. Add wires to the control cabinet and connect analog signals to the control room for remote control.
Of course, remote start can be achieved by adding an instrument PLC control cabinet and a set of control software. Combine remote start with on-site start. The first few remote starts must be monitored by someone on site. In the event of an accident, the advantages of stopping the machine directly on the computer will be fully realized.