Shutdown of the SWP-C80 inspector channel
Thread Content
There is an SWP-C80 inspector on site to monitor the readings of the thermocouples. This inspector is originally set up for 8 channels of inspection, but only two thermocouples are in use at the site, occupying those two channels. It is very time-consuming to display the inspection status of all 8 channels during each inspection; how can I disable the channels that are not in use?
Just set it in the secondary parameters. The symbol -n01 refers to the switch for the first channel: it is set to 0 to turn on the first channel, and to 1 to turn it off; the same principle applies to the other channels.
It should be possible to fix the display of parameters for 1 channel; I haven’t tried the method mentioned above, but you can give it a try!
I’ve tried the method suggested by my friend hx872; after making the settings, an error with the code -OH- occurred, and it couldn’t be displayed properly.