Thread Content
Overview of PowerChrom chromatography workstation software: The PowerChrom chromatography workstation software runs on Windows or Macintosh computer operating systems, and is used for collecting, displaying, and analyzing chromatography data. Turn your PC or Mac into a chromatography data workstation – no programming required; it’s plug-and-play. It can acquire signals from one or two detectors, with an accuracy of up to 24 bits. The input gain can be independently selected from ±2 mV to ±10 V. Digital signal processing ensures an excellent signal-to-noise ratio. Features such as TTL or contact closure control for the automatic sampler are available (PowerChrom 280 system). It is compatible with USB 2.0 and 1.1. The PowerChrom chromatography workstation software can be used as part of the PowerChrom 280 chromatography workstation system, as well as with the e-corder201 or 401 data recording systems, for acquiring signals within a voltage range of ±10V. It is possible to record signals from one or two chromatographic detectors. The vast majority of chromatographic detectors with \"recorder\" or \"integrator\" output ports can be used with the PowerChrom chromatography workstation. Upgrade your chromatograph. PowerChrom is an ideal chromatography data acquisition system for upgrading your existing GC or HPLC. Abandon tape-based chart recorders, integrators, and DOS-based systems; use the latest generation of computer technology instead. Automatic or manual operation (depending on your chromatograph configuration). Automatic samplers and fragment collectors can be controlled by contact closure or TTL signal triggering. Serial files can be used to control the execution of multiple experiments (PowerChrom 280 chromatography workstation system). The Good Laboratory Practice GLP PowerChrom design helps you comply with Good Laboratory Practices (GLP): all experiments are dated and timed, the methods used for data collection and analysis are recorded, detailed annotations facilitate the storage of observations, and the number of samples is clearly indicated. Data is automatically saved to the hard drive every 30 seconds, allowing recovery in case of power loss. All information (methods, calibrations, peak reports, and raw data) is stored in a convenient data file. Up to 999 experiment run results can be saved in the same data file! The data file is compatible with Windows and Macintosh computers. All intermediate versions of the calibration tables are available. It provides user-friendly output options: you can export the original chromatograms (in graphical or tabular form), peak reports, method, and sequence tables to other graphic design software, word processing programs, and spreadsheet applications. Manual peak editing: For those peaks that are indeed difficult to handle, and when adjusting the automatic threshold proves time-consuming and tedious, manual peak editing can be used to add, delete, remove, or otherwise edit such peaks directly—just point and click! The correction response function allows for fitting the correction curve using linear, quadratic, or even point-to-point (linear interpolation) response methods. Automatic sequence operation: When an appropriate auto-sampler is used, a sequence file can be employed to automate a series of experiments (PowerChrom 280 chromatography workstation system). In digital signal processing, PowerChrom first takes additional samples of the signal, and then averages the readings of each collected data point. The signal-to-noise ratio is improved by the factor √n, and “n” is also averaged during reading. For noisy signals, this can improve the signal quality by an order of magnitude or more. More importantly, at a sampling rate of 40/s or lower, the signal is averaged over the entire power supply cycle (for 50 or 60 Hz power grids), which allows AC interference to be eliminated; AC interference is often the main source of \"noise\". Therefore, you can always obtain the highest-quality data from your detector.