How to use ASPEN to look up material properties
Thread Content
First, define a unit. Generally, HEATER is chosen; as long as the heat power input is set to 0, the physical properties of the material entering and exiting remain the same. Then enter the physical property conditions to be queried in the input field. Then perform the calculation. The physical property conditions required for the query can be seen in the results. If you are looking for some special values that are not available by default, you can use the following method to search for them! Create a new property target in properties---prop-sets, then select the unit value you want to know about, and add this value to the property sets in setup----report options----stream. Once the calculation is done, the value can be seen in the results.
The method below might be better, hehe. After all, it’s still necessary to enter heat flow = 0. With a mixer, all that’s needed is a single click, without any data entry required.
There’s no need to go through such trouble; after selecting the material, simply click “review” below to view various basic physical property parameters