【Daily Question 20090227】Installation Order
Thread Content
In the same process pipeline, where are the temperature measurement points, pressure measurement points, and flow rate measurement points located? What is the order of installation? Answer: 1 Flow rate 2 Pressure 3 Temperature. Last edited by Chifeng on 2009-2-27 07:40.]
Pressure measurement points, flow rate measurement points, and temperature measurement points are arranged in sequence along the flow direction of the medium in the process pipeline.
Flow rate, temperature, pressure.
You can check the \"Specifications for the Construction and Acceptance of Chemical Process Instruments\"; it contains uniform regulations regarding the installation sequence and location of temperature, pressure, and flow measurement devices on the same pipeline.
Flow rate, pressure, temperature. Last edited by chmyh on 2009-2-27 08:42 in this post.]
Based on my recent experience drawing PID diagrams, it’s temperature, pressure, and flow
No way. Aside from the editor upstairs, did no one get any questions right?
The order should be pressure first; temperature and flow rate can be interchanged, but in all cases the requirements regarding the straight pipe section for the flow measurement instrument must be met. There are some in the specifications
My answer: First is pressure, then temperature, and finally flow rate
Pressure measurement points, flow rate measurement points, and temperature measurement points are arranged in sequence along the flow direction of the medium in the process pipeline.