What should I do if there is a leak in the top or bottom three material pipelines of the synthesis tower? ?
Thread Content
During the ammonia pressure boosting process, the top cover of the synthesis tower or the three material pipelines at the bottom of the tower leak. How to deal with it? This post was last edited by lxq700918 on 2009-2-27 14:35 ]
what to do? Pressure relief treatment, the purpose of ammonia circulation is to find leaks and deal with them.
"During the ammonia pressure boosting process, the top cover of the synthesis tower or the three material pipelines at the bottom of the tower leaked." Answer: Stop the pressure increase immediately, check the leakage carefully and carefully on site, and find out if there are any other leakage points. After the pressure is released, take measures to deal with the leakage point (tighten or replace the cushion), and then increase the pressure after the completion. Notice: After a leak is discovered, it is best not to continue to pressurize and cause a safety accident or cause the sealing surface of the leaking part to be washed away and grooved, making it difficult to clean up.
Make a short stop immediately, and process personnel will handle the pipelines and equipment for maintenance.
Emergency pressure relief, conduct a thorough inspection, find out the cause, and then carry out maintenance.
Ammonia leaks when the pressure increases, so quickly release the pressure and stop the vehicle to deal with it!