Mechanical seal leakage
Thread Content
If the set screw of the rotating ring in a mechanical seal is not tightened, will this cause leakage in the seal while the centrifugal pump is operating? And does the leakage occur from the very beginning or only after the pump has been running for some time? (I think it will be leaked myself)
The mechanical seal has a spring on the moving ring; if it’s just not tightened properly, as long as it’s installed evenly, there is usually no leakage.
If the set screw is not tightened properly, it will definitely cause leakage in the mechanical seal, and leakage will occur as soon as it is turned on
It depends on how the shaft sleeve and the moving ring are positioned. It’s better if positioning is done via the shaft pedestal, as the moving ring seat rests on the shaft pedestal, so the impact is relatively small； If it is a smooth bushing, and positioning on the bushing relies on the set screws on the moving ring, then leakage will definitely occur. When the moving ring is compressed, it becomes loose on the bushing, resulting in some displacement; this leads to insufficient pressure between the sealing surfaces of the moving and stationary rings. So, won’t there be leakage? Therefore, after adjusting the position of the moving ring, it is essential to tighten the set screws symmetrically to prevent the seat from shifting, so as to avoid losing the compression amount that was painstakingly adjusted!
Setting the set screw is meant to tighten it.
This is a modular seal; the shaft sleeve is smooth, and the moving ring is fixed to the shaft sleeve by set screws
It must have been missed. Take a look on the fourth floor and you’ll know everything.
Yes, in this way the moving ring might move around; it may not be pressed tightly or evenly
The moving ring set screw is used to adjust the degree of compression. If this screw is not tightened properly, it may cause the moving ring to rotate relative to the shaft. There is a shoulder as well as an O-ring or V-ring in place between the moving ring and the shaft sleeve, and as long as the O-ring or V-ring fits tightly against the shaft sleeve, no leakage will occur. When the set screw becomes loose, as is commonly the case, the O-ring or V-ring may wear out quickly due to rotation against the shaft sleeve, which is why leakage occurs in the seal
Is there such a modular mechanical seal? The optical axis sleeve allows for free adjustment of the position of the moving ring, that is, it enables adjustment of the compression amount; it usually has a positioning platform inside the sleeve ； The modular mechanical seal, also known as a quick-install mechanical seal, features a smooth inner sleeve that can move freely on the shaft; the entire seal is installed on the equipment first and then positioned on the shaft.
I think it will definitely get leaked. Because if the top is loosened too much, the compression amount changes