The methods to prevent dust accumulation are those
Thread Content
What are the ways to prevent dust accumulation?
Could you tell me where dust accumulation should be avoided?
Choose the appropriate flue gas flow rate! This post was last edited by eddy-8280103 on 2009-2-28 08:33]
During production, it is necessary to closely monitor the changes in temperature at various points of the boiler; however, when the temperature is higher than usual, soot blowing should be carried out promptly! ! Ensuring the effectiveness of soot blowing will prevent soot accumulation! !
1. Use the soot blower properly. 2. Ensure an appropriate design for the flue gas flow rate; too low a flow rate can lead to dust accumulation, while too high a flow rate causes high resistance and erosion of the pipe system. 3. The angle of the flow divider plates should be designed appropriately. 4. Stop the furnace immediately for repairs in case of leaks inside the furnace, as high flue gas humidity facilitates dust accumulation. 5. Make sure the surface of the cyclone is as smooth as possible, and that the width of the discharge opening at the bottom of the cyclone is appropriate, otherwise dust accumulation in the form of arches may occur. 6. Other points (I’ll summarize them and add them later): lol