Regarding the supporting issues of air separation automatic control system
Thread Content
Dear heroes, our air separation instruments are provided by the air separation supplier, and the automatic control system is designed and matched by a design institute, so there may be matching problems between the automatic control and the instrument. Do you have any good suggestions or opinions?
I think your air separation is still in the design stage. There is nothing wrong with the complete control system of the design institute. If there is a problem, it is often a communication problem. Good project management is very important. At the same time, as the owner, you should spend more energy coordinating manufacturers and design institutes to identify problems and correct them in time. Good luck with your project.
What I am worried about now is the design capabilities of the design institute. This is the first time that the design institute has carried out air separation design.
If it is your first time to design an air separation system, there will be many problems, and you will probably be busy.
This issue requires communication and the design should be based on equipment supply. You can't just provide what others need for their design. There are a lot of tricks here, especially the design department that needs to pay attention to control.
If it is the first time for a design institute to engage in air separation design, then the control system may not be the only issue to worry about. The design of the entire plant is the most likely to cause problems. Because they have no experience, the control system is a small case. After all, the control logic is provided by the air separation manufacturer.
The biggest shortcoming of design institutes is that they talk on paper, and many things are borrowed. If you want to not passively strive for more reasonable installations, the most important thing is to visit and learn from similar installations in China, and then strengthen communication with design institutes. This may be better!
Nowadays, many manufacturers have molded products, so it is best to buy them directly from the manufacturer!