Questions about aspen plus 2006 installation
Thread Content
After I reinstalled the system, I installed aspen plus 2006. After installing and opening it, a prompt window appeared. The content is as follows.: aspen plus version 20.0 could not locate the registry entry for the data browser menu database. data entry and results forms will not be available. When running, only the process can be drawn, and data cannot be entered. The system does not respond when clicking the databrowser, and then enters a crash state (no response). I would like to ask everyone, what may be the reason? Has any colleagues encountered this problem? Thanks!
I have not installed it in 2006.5. I am currently experimenting with V7. However, no experiments have been successful so far. hehe. Will continue the experiment tomorrow.
Can anyone on the 2nd floor send me v7? My qq 491705870, add me haha
The problem was solved. It turned out to be the operating system.
Mine is from ASPEN2006, but I won’t be in your situation!
If the conditions are not set correctly, MISSY will appear, asking me to send an error report, and then close!
I originally used the system restored by ghost, but failed to install it many times. I later changed the operating system and installed it, :lol :lol :lol
Remember to back up after installing aspen
The installation guide says You may encounter error messages when starting the Aspen Plus User Interface or when attempting to run a simulation: Message When starting the Aspen Plus User Interface this message appears: Aspen Plus Version could not open the Data Browser menu database. Data entry and results forms will not be available. Cause The installation did not correctly build the Data Browser and Forms database file, ApwnMenu. This file, located by default in C:\Program Files \AspenTech\Aspen Plus V7.0, should always be larger than 1 MB. Solution 1 In a Command Prompt (DOS) window, run the APFormSetup.exe utility. The default location is: C:\Program Files\AspenTech\Aspen Plus V7.0\GUI\XEQ. 2 On the Register Forms dialog box, accept all defaults; then click Next. 3 On the Register PlotWizard dialog box, accept all defaults; then click Finish.
The above is what is said in aspen plus 7.0. It is also said in aspen plus 11.1. Message When starting the Aspen Plus User Interface this message appears: AspenPlusVersion11.1couldnotopenthe DataBrowsermenudatabase.Dataentryand resultsformswillnotbeavailable. Cause The installation did not correctly build the Data Browser and Forms database file, ApwnMenu. This file, located by default in C:\Program Files \AspenTech\Aspen Plus 11.1, should always be larger than 1 MB. Solution 1 In a Command Prompt (DOS) window, run the ApwnSetup.exe utility. The default location is: C:\Program Files\AspenTech\Aspen Plus 11.1\GUI\xeq. 2 On the Update System Registry dialog box click Next. 3 On the Register Forms dialog box accept all defaults and click Next. 4 On the Register PlotWizard dialog box accept all defaults and click Finish. However, I have not been successful in using it so far. Please give it a try.
This solution is useless if there is a problem with the system.