TASC shell side inlet is saturated water vapor
Thread Content
The TASC operation prompts that my water vapor density is too small. It must be that TASC thinks the inlet is liquid, but I don't know where to change the water vapor feed. Please enlighten me heroes, thank you. :) :) :)
The density of water vapor and water is very different! There's no mistake!
Is there something wrong with losing under pressure? !
Is there something wrong with the pressure? The value of losing is too small?
When setting stream conditions, you can choose one pressure or temperature (because the saturation temperature or pressure calculated by the thermodynamic method deviates somewhat from the actual one, but not much, so do not specify these two parameters at the same time), and the other uses the gas phase volume fraction. When 1 is selected, the material is saturated steam, and when 0 is selected, the material is liquid in a saturated state.