Can supporting bearings be used for horizontal boilers?
Thread Content
In JB/T4712.4-2007, support supports are used for vertical vessels. Can they be used as supports for horizontal boilers? If possible, how to check? May I ask what form of supports are used in the horizontal hot water boilers and steam boilers you design?
Mainly to consider thermal stress issues, expansion joints must be installed and sliding guides must be added!
Can you explain it more clearly? I still don't quite understand, thank you!
Generally, the supporting bearing is not used, and the saddle bearing in JB/T4712 can be used.
Using JB/T4712-2007 "Container Supports", the saddle supports are divided into heavy and light types. The selection is generally based on the barrel diameter and load-bearing capacity. This post was last edited by Wu Xiao on 2009-3-11 17:04 ]
Standard things are generally fully proven. If there is no suitable reason, it is recommended to use a saddle support.
Sometimes saddle-type supports are used, and there are no special requirements for this boiler. At least I didn't find it.
It seems that the boiler itself has a base when it leaves the factory. . I see that the customer does not need any brackets in the pictures after installation. After all, the horizontal type has a large volume and a low center of gravity, and the vertical type has a higher center of gravity, so it is needed.