Pull rod arrangement

2009-03-13View Original

Thread Content

I now have a vertical heat exchanger, with the hot fluid entering from below and exiting from above, and the cold fluid entering from above and exiting from below. Why is the end of the tie rod that is screwed into the tube sheet on the upper side, while the nut connection is on the lower side? This post was last edited by 0536dai on 2009-3-13 09:11]

Reply #22009-03-13

Tie rods perform better under tensile forces than under compressive forces.

Reply #32009-03-13

There are many discussions on this topic in the forum; for example: http://bbs.hcbbs.com/viewthread.php?tid=352138&highlight=%C0%AD%B8%CB. If you search for “pull rod”, you will find plenty of results

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.

Pull rod arrangement

Thread Content

Related Threads in This Forum

← Previous

Next →

Submit a Project

Disclaimer

Quick Links