Can I use the format brush to make annotations? Why hasn’t there been any change after I brushed it? Please give some advice
Thread Content
Can I use the format brush to make annotations? Why hasn’t there been any change after I brushed it?
It should work, unless you blow up the markings. Which version of CAD are you using?
It works; if you use the same labeling style, there definitely won’t be any changes
It can be brushed; both of the above possibilities apply
It depends on the specific situation. Generally, a floor plan is sufficient. If there is an inclination in the axonometric view, it won’t be possible to paint over it. Please explain in detail, and a screenshot would be better.
It works. If you use the same annotation style, there won’t be any changes. But if you alter the annotations, it still won’t work~～
You can adjust the text size, arrow size, and color; anything that can be modified in the annotation style can be changed
Sure, you must have removed the X mark~:lol
If the characteristics of the two annotations are the same, then there is no change. Characteristic matching is quite useful; if that doesn’t work, try it in the annotation style settings
:funk: :funk: I suspect you’ve blown the standards apart~
You can brush it, and after that, the linear proportions and everything else will become exactly the same as those in the source file!
It works; I often use this command. It’s possible that you have broken down the annotations.
It will definitely work; before doing it, make sure that the formatting style has been successfully modified and that Enter has been pressed. I make such mistakes sometimes too.
If the Tenso software is installed, the format brush will not work when CAD is opened.