Need help with the calculation of the load capacity of a tablet
Thread Content
It is a jacketed vessel with a semi-circular lower part and vertical plates on both sides of the upper part. The wall thickness of the semi-circle can be determined according to the GB150 standard; but how is the minimum wall thickness for those vertical plates calculated? Steam medium, 0.5 MPa, temperature 200. Thank you all for your help
Are the upper sides vertical plates? I’m not fully sure what it is; is the seal at the upper end of the jacket a ring plate? If so, the calculation method outlined in Appendix J9 of GB150 can be used. If not, I guess my level is only that of a kindergarten student, haha.
Yes, it’s a jacketed structure: there’s a conical seal at the top, followed by a flat section at a certain height; below that is the original bottom jacket. How should the wall thickness of the middle flat section be determined? Thank you
In accordance with GB150, Figures in Appendix J9 of P236~P237 and the corresponding calculation formulas shall be used; note that an additional thickness value must be added after the calculations are completed.
This is the calculation for the jacket seal; there is a straight section below the seal, followed by a semi-circle. How do I calculate the wall thickness of this straight section? Thank you