[Phase 1 of Time-Limited Quick Response Contest] 011 [Completed]
Thread Content
Rules: 1. If you want to answer immediately, give a score of +1 wealth to floor 1 and write your answer in the “Reason for action” field (only the content within parentheses); see the diagram below for details. 2. One “*” represents 1 Chinese character (or 1 digit), and the answer must match exactly to be considered correct. 3. The first person to answer correctly will receive +10 wealth points; please reply in the replies on floor 2 and below to claim the reward ； 4. The scope of questions covers the commonly used standards and experience manuals for the process and piping fields ； 5. The difficulty level of the questions increases from easy to difficult. 6. Lower-grade students are welcome to participate actively. Question for this issue: 011. Brackets should be installed near the pipe openings of sensitive equipment (pumps, compressors, etc.) to prevent (***********). Standard answer: The pipe load acts on the device’s pipe outlet. Winner: Seeking help. This post was last edited by hutom123 on 2009-3-25 09:34.]
I can’t give a rating, so I can only reply; please forgive me, original poster. The answer is as follows: Brackets should be installed near the pipe ends of sensitive equipment (pumps, compressors, etc.) to prevent (pipe loads from acting on the equipment’s pipe ends). This post was last edited by zhencht on 2009-3-16 09:11]
Piping loads act on the equipment pipe ends
Brackets should be installed near the pipe ends of sensitive equipment (pumps, compressors, etc.) to prevent (pipe loads from acting on the equipment’s pipe ends).
The answer is: Brackets should be installed near the pipe connections of sensitive equipment (pumps, compressors, etc.) to prevent (the load from the pipes from acting on the equipment’s pipe connections)
Answer: Brackets should be installed near the pipe connections of sensitive equipment (pumps, compressors, etc.) to prevent (the load from the pipes from acting on the equipment’s pipe connections)
Brackets should be installed near the pipe ends of sensitive equipment (pumps, compressors, etc.) to prevent (pipe loads from acting on the equipment’s pipe ends).
Piping loads act on the equipment pipe ends