Is it possible to change one variable according to a certain pattern in order to obtain a series of results for another parameter?
Thread Content
Typically, in the simulations I do, I enter a value for a variable, run the simulation to view the results, and then manually enter the parameters needed from those results into Excel. Every time the value of a variable is changed, it must be run and then inputted. If more parameters are required, a great deal of manual work will be needed. Is there any good way to reduce this workload? In pro2, is it possible to change a variable according to a certain pattern in order to obtain a series of results for another parameter?
The corresponding results can be outputted.
Using case studies for condition analysis is very convenient; in earlier versions, sensitivity analysis can also meet your requirements