How is the extension length of the outlet pipe at the bottom of a vertical container determined?
Thread Content
There is a pipe connection at the center of the lower head, from which a 90-degree elbow leads horizontally outward. How should the length of this outlet be determined?
Led out to the outside of the housing for easy installation.
1. Meet strength requirements... 2. It should be convenient for piping...
If it is a skirt support, then the length to which the outlet pipe nozzle extends from the skirt cylinder is similar to the external extension length of the nozzle specified in the HG standards. In the case of a supporting type bearing, the extension length of the outlet pipe is measured with reference to the outer wall of the cylinder; in accordance with the standards regarding the extension length of connectors, it can also be shorter than the specified value as long as installation is not affected.
In my opinion, the overhang length should be determined primarily with ease of installation in mind, but support must be added. The specific location can be referred to as specified in the HG standards.