[Phase 1 of Time-Limited Quick Response Contest] 043 [Completed]
Thread Content
Rules: 1. If you want to answer immediately, give a score of +1 wealth to Floor 1 and write your answer in the “Reason for action” field (only the content inside the parentheses); see the diagram below for details. 2. One “*” represents 1 Chinese character (or 1 digit), and the answer must match exactly to be considered correct. 3. The first person to answer correctly will receive +10 wealth points; please reply in the replies on floor 2 and below to claim the reward ； 4. The scope of questions covers the commonly used standards and experience manuals for the process and piping fields ； 5. The difficulty level of the questions increases from easy to difficult. 6. Lower-grade students are welcome to participate actively. Question for this issue: 043. To prevent steam from carrying water, (****) must be installed at the point where steam enters the device and at the end of the steam main. Standard answer: Water diversion facility. Winner: joy2016. This post was last edited by hutom123 on 2009-3-25 08:38.]
Where a saturated steam main enters the unit, a steam trap should be installed near the boundary on the unit side, with regular drainage measures in place below the steam trap. How do you want me to fill it in? I think both the water separation device and the hydrophobic device are suitable.
Drain interface. Last edited by brightlord on 2009-3-20 17:20 in this post.]
Hydrophobic valves must be installed in steam pipelines. What needs to be installed at the end of the main pipe is a gas-liquid separator (vapor drum)
:call: :handshake