[Phase 1 of Time-Limited Quick Response Contest] 052 [Completed]
Thread Content
Rules: 1. If you want to answer immediately, give a score of +1 wealth to Floor 1 and write your answer in the “Reason for action” field (only the content inside the parentheses); see the image below for details. 2. One “*” represents 1 Chinese character (or 1 digit), and the answer must match exactly to be considered correct. 3. The first person to answer correctly will receive +10 wealth points; please reply in the replies on floor 2 and below to claim the reward ； 4. The scope of questions covers the commonly used standards and experience manuals for the process and piping fields ； 5. The difficulty level of the questions increases from easy to difficult. 6. Lower-grade students are welcome to participate actively. Question for this issue: 052. For complex pipelines, fixed points can be used to divide them into several sections with simpler shapes, such as (****), (****), (****), etc., before conducting analysis and calculations. Standard answer: L-shaped pipe section; gate-shaped pipe section; Z-shaped pipe section. Winner: huaweizhou. This post was last edited by hutom123 on 2009-3-25 at 15:44
For complex pipelines, fixed points can be used to divide them into several sections with simpler shapes, such as L-shaped sections, U-shaped sections, Z-shaped sections, etc., to facilitate analysis and calculation:
L-shaped pipe section, U-shaped pipe section, Z-shaped pipe section
L-shaped pipe section, U-shaped pipe section, Z-shaped pipe section
052. For complex pipelines, fixed points can be used to divide them into several sections with simpler shapes, such as (L-shaped sections), (π-shaped sections), (Z-shaped sections), etc., for further analysis and calculation.
L-shaped pipe section； Gate-type pipe segment ； Z-shaped pipe section