Problem starting Microstation in Intools to generate loopdrawings?
Thread Content
I clicked \"Generate Loop Drawing\" in the Loop Drawing module of Intool, but MicroStation does not generate it automatically. Does anyone know how to set this up?
In intools, it shows that generation has been completed, but the generated loop drawing cannot be seen at all in MicroStation. :'(
The version of Intools I’m using is 6.0, and MicroStation is SE.
Han, does 6.0 support mircostation? I really don’t know if it’s supported. Generally, control system designers still use AutoCAD. I was too lazy to do further development on Enhance smartloop, so I used this tool to generate the loop drawing instead. Understanding the definition of CAD requires patience.
I was wondering if any macros have been defined in your Mircostation, and whether it has been set in the properties to use Mircostation for generating loops. It is also necessary to define paths, temporary files, etc. I’m not sure if the original poster has made these settings; I’ve tried both CAD and Mircostation with no issues