Could you please tell me if Yokogawa CENTUM CS3000 can be installed on Windows Vista?
Thread Content
Could you please tell me if Yokogawa CENTUM CS3000 can be installed on Windows Vista?
Yes, I have installed CS3000 on my computer and used the test function. It can be used. Because I only used the simulation test function, I don’t know whether it will be stable or unstable during normal production.
Where did you get the installation software upstairs?
Yokogawa CENTUM CS3000 does not specify that it can be used on Windows Vista. It is recommended not to use it under Windows Vista for official use. Yokogawa's newly launched CENTUM VP system can be used under Windows Vista.
I installed it on my own computer and found no problems (Windows Vista), but I haven't tested it on the operation station or engineering station. I guess there won't be any problems. However, the manufacturer requires an XP environment. Auto-control personnel should not take this risk. It is meaningless!
It should be useful for practicing* Yes, the new version of centum vp runs under vista.
Looking forward to it, but has anyone used vitsa? It seems not as easy to use as xp.
CS3000 can be upgraded to CENTUM VP. One of the methods is to upgrade the operating system to WINDOWS VISTA and then apply the software upgrade, because some software functions of the VP system are based on WINDOWS VISTA. So there should be no problem using VISTA with CS3000. This post was last edited by wopale3 on 2009-4-1 14:26 ]
CS3000 version R3.08.50 and above can be installed on VISTA. Versions lower than it cannot be installed or the project cannot be opened after installation. In addition, your KEYCODE must have some basic software packages, such as testing software packages, control chart status display software packages, drawing software packages, etc. Without corresponding software packages, certain functions cannot be implemented. The above is what others replied to me and I will share it with you.
Friend, why can’t my VISTA system install cs3000? No matter how hard you put it on, you can’t fit it in! I just can’t pretend until the last step! Prompt that DDE is not supported! How did you pretend? Can you tell me? Okay, please add me QQ271765791 This post was last edited by chmyh on 2009-4-5 17:54 ]
My software is version R3.07.00, why can’t it be installed? Fainted me!
We recently had a foreign project client who requested to use the Vista system. We asked Yokogawa and said that the new version can be installed.
Versions before CS3000 3.8 are only available on XP. As the poster said, CENTUM VP can be installed on VISTA!
CS3000 requires XP SP2, CENTUM VP requires VISTA Business Edition!