I would like to ask, after the sinking cylinder liquid level gauge is removed, can it be placed flat? Why?
Thread Content
I would like to ask, after the sinking cylinder liquid level gauge is removed, can it be placed flat? Why? What should I pay attention to after disassembling the sinking cylinder liquid level gauge? Thank you!!
Why can't it be laid flat? There is also a time when the sinker tube should be laid flat before installation.
It is good to lay it flat before installation, but manufacturers usually have fixing measures on the bottom to prevent the pontoon from tilting.
Generally, they can be laid flat, and the manufacturer fixes them to prevent vibration during transportation!
It can be laid flat, and it is best to fix or remove the float during long-distance transportation to avoid damaging the torque tube.
Why do you ask? Isn’t it normal to lay it flat? Do you still want to put it up?
Just let the sensor be in a free state and not affected by external forces. Place it however you find convenient. Make sure the sensor cannot bear the force.
Didn't the original poster remove the sinking tube liquid level gauge and still keep the tube? Just remove the float and that's it.
When placing the sinking tube level gauge, be careful not to be affected by external forces, especially the torque tube part! Do not subject the sinking cylinder to impact during disassembly and storage to prevent deformation! The circuit board part must be kept well and not affected by moisture! :handshake
It is okay to lay it flat, but be careful not to roll it randomly, which may cause the float to get stuck.