Can gaskets be reused?
Thread Content
During on-site maintenance, gaskets often need to be replaced, but most of them appear to be fine upon visual inspection. If the removed gasket is not damaged, can it be reused? This can reduce maintenance costs!
According to the specifications, the gasket should be replaced; as for the cost aspect, it depends on the situation. However, in the case of wound gaskets, it is necessary to check whether there are any through-holes in the sealing surface – if so, they cannot be used. It’s better not to use asbestos boards.
According to the specifications, it is generally used once. Metal wound gaskets and rubber asbestos gaskets should not be used. A metal spring washer can be used. Furthermore, asbestos is prohibited in some local regulations due to its harm to human health.
Generally, those that have been pressurized need to be replaced
Gaskets cannot be reused; once they have been compressed, they must be replaced whenever the pipeline is disassembled. There’s no need to save on this expense
It’s not supposed to be in use according to the rules; what if it gets leaked?
It can be reused or used at a lower standard when the pressure is not high and the quality of the gasket is acceptable.
Cost reduction doesn’t have to come from gaskets; think about how much a single gasket costs – what’s important is to ensure safe production； Technological innovation is what matters most; it is the key to cost savings
From a safety perspective, it cannot be reused; from the standpoint of energy savings and reduced consumption, it can be used at a lower level, for example in water systems with low pressure.
Gaskets must never be reused. Firstly, they may already be damaged after being removed, especially damage that is not visible to the naked eye, which can affect their sealing performance. Secondly, after compression, the elasticity of the material inside the gasket changes; therefore, a greater preload is required when using it again to ensure sealing. Increasing the preload may have adverse effects on components such as flanges.
Thank you all for your answers. I have two more questions: First, are asbestos gaskets toxic and harmful to humans? Second, the issue of downgrading gaskets refers to whether, after removing those rated at 2.5 MPa, they can be used on flange sealing surfaces rated at 1.6 MPa if there are no problems
In our factory, there is absolutely no practice of reusing gaskets; even small gaskets can lead to material leaks, which are the cause of accidents! It’s better to use it with caution. . .
Gaskets must never be reused, as used gaskets lose their elasticity, which in turn results in poor sealing performance.
Replace it in accordance with the specifications – don’t lose the big picture over small details!
Under no circumstances should it be reused – the failure rate is too high; we have learned from past experiences in this regard.
It can be used in ordinary low-pressure water pipes
“Where did the claim that “asbestos gaskets are toxic and harmful to humans” come from? ? Gaskets of different grades have varying thicknesses and other specifications, and generally cannot be substituted for one another. It’s better not to skimp on this money
Asbestos gaskets are no longer used at all, especially in foreign projects. It is best not to reuse other gaskets, especially on pipelines carrying toxic fluids; safety must come first.
It’s best not to reuse it; the small loss isn’t worth the bigger one
It is best not to reuse the gaskets that have been replaced, especially metal wound gaskets. If the asbestos gasket shows no significant deformation, breaking, or moisture, and if the pressure of the medium inside the pipeline or equipment is not high nor is the temperature high, then it can still be considered for use with media such as water. But safety first – try not to cut costs here, haha!