Consult colleagues from the design institute about CAD layout drawings?
Thread Content
Can anyone use CAD layout to produce drawings? Could you please tell me how to draw the upper and lower layers? Do you see different planes in the model?
The question you asked sounds a bit general. I am not from a chemical engineering design institute! Just to give you some advice, I usually draw pictures in paper space, using the insert layout or create layout wizard, and select the required drawing banner during the process. For example, A4, A3, A2, A1, A0, etc. Of course, before drawing, I usually draw a proportioned drawing basket in the model space. So that you can print it out after making the picture. Hope this helps! ! !
The floor plan needs to be divided into different floors, and the foundation, reserved holes, and pre-buried equipment must be reflected. Choose A4, A3, A2, A1, A0, etc. according to different picture sizes. Generally, A4 is too small and is rarely used.
You can do this if you want: 1. Different contents are distinguished by layers. 2. You can choose to print a certain layer when drawing. For example, in the layout, you draw 12345 layers together. When using the layout to draw a picture, you create 5 layouts, and each layout can print any one or several layers among them. This method is super, super practical!