Issues with TASC version 5.1 operation

2009-03-31View Original

Thread Content

Recently, a pirated version of TASC 5.1 was installed. When performing calculations for shell-and-tube heat exchangers, it was found that when the tubes were arranged at 30 degrees, changing the baffle cut ratio had no effect on the calculation results, which remained the same as the initial cut ratio values; this applied especially to the flow rate in the shell side. Only by changing the arrangement of the tubes can the effect of the cutting rate on the heat recovery effect be reflected. I’m not sure if there’s a default setting somewhere; I’d appreciate it if you all could give me some advice. Thank you.

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.

Issues with TASC version 5.1 operation

Thread Content

Related Threads in This Forum

← Previous

Next →

Submit a Project

Disclaimer

Quick Links