Regarding the plant’s water balance!
Thread Content
To conduct a mass balance calculation for the entire plant, how can the wastewater discharge volume of the equipment be determined?
After calculating the evaporation amount, determining the water replenishment volume is equivalent to determining the wastewater discharge volume.
There is relevant information on the forum; you can look for it yourself. It is usually calculated on a percentage basis
Dude, what industry are you in? To determine the waste discharge volume of a device, it is first necessary to know the following parameters: 1. What medium is present inside the device? 2. What is the water vapor concentration? 3. What is the dew point temperature? 4. What are the operating pressure and temperature, respectively? 5. What is the medium flow rate? Only after the above parameters are determined can its pollution discharge amount be calculated.
It should be the mass balance of the medium; the amount of water added minus the amount of water that evaporates equals the amount of wastewater discharged