Issues viewing calculation results
Thread Content
How can I adjust the units of the calculation results? As is usual*, units like °C, kPa, kg/h, and mass fraction are used; why are the results filled with things like mol, bl, k, psi, etc.? I’ve expressed my thanks already; I’m just starting out, so I hope everyone can give me some guidance
There’s another question; let’s ask it here too, :) For distillation columns, where can one check the heat loads of the condenser and reboiler?
Let’s talk about units first. At the beginning, you already choose the unit system in which to perform the calculations; therefore, the units used in the output are the default units of that system. If you need other values such as mass fraction and they aren’t included in the calculation results, you can set them in the \"Stream\" option under \"Report Options\" within the overall setup. The heat load of the distillation tower can be seen in the results of the module you selected.