Ladder platform pad

2009-04-03View Original

Thread Content

For the ladder platform pad of horizontal containers, is it necessary to leave a 10mm gap without welding? Is this done to allow air to escape from within the pad?

Reply #22009-04-03

10 mm should be left unwelded, located at the very bottom; this is for exhaust. Additionally, if other areas are not sealed, it also facilitates the outflow of water

Reply #32009-04-03

It can be said that this requirement applies to all shims, although some use the method of drilling holes in the shims.

Reply #42009-05-22

This is necessary, but a 6MM hole can be made in the pad, OK

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.

Ladder platform pad

Thread Content

Related Threads in This Forum

← Previous

Next →

Submit a Project

Disclaimer

Quick Links