Diesel intermodal transport
Thread Content
There have been fewer arrivals recently, mainly because the facility is currently busy with diesel intermodal transport. We feed diesel into the fractionation tower at the diesel extraction port for cold oil transfer, and then heat it to 150 degrees for hot oil transfer and hot tightening. Are you all using new equipment for diesel combined transport into the tower? Hehe, once these tasks are done, it’s time to steadily increase profits! The dryer will be ready around the 18th; it should be functioning normally by the end of the month!
During oil intermodal transport, diesel naturally has to go into the tower.
Diesel oil transportation serves, on the one hand, to clear the dead zones in water transport and to detect leaks. On the other hand: test the tower’s instruments in advance. I have some doubts about the temperature mentioned by the original poster: it should be over 200 degrees.
1. Purpose of combined water transportation: ① Through combined water transportation, the pumps, towers, containers, pipelines, and control systems are operated together for an extended period of time, thereby putting further stress on the equipment and process pipelines. ②Through combined water transportation, the accuracy of instrument readings and their control performance are further tested. ③Further flush the pipelines and equipment through water circulation. ④Improve the operational skills of the operators. 2. Purposes of oil transfer operation: ① Through oil transfer operation, the pumps, towers, vessels, pipelines, and control systems are operated with oil for an extended period of time, thereby further testing the suitability of the equipment and process pipelines for handling oil products. ②Through oil intertransport, the accuracy of instrument readings and their control performance are further tested. ③Through oil transfer, the water remaining in towers, containers, and pipelines after water transfer is carried out of the facility, thereby purifying the system environment. ④Simulate normal production to test the performance of pipelines, equipment, pumps, DCS systems, and instruments, improve the operational skills of operators, and create conditions for commencing operations. ⑤Expose and identify issues that were not detected during the design and construction of the device. I’m not sure what kind of equipment you have; as for what I know, hydrogenation units are used for the distillation process, and water and oil transportation is related to that same distillation stage – it definitely goes into the tower! During the hot oil transportation process, heat tightening is generally carried out at 200 degrees
Diesel intermodal transport definitely requires use of the tower; check the tower’s sealing as well as the instruments, etc
Oil transportation shall be carried out after water transportation is completed